Elegant Plastic Dispenser
If you're using clear labels with this dispenser, you may need to gently compress the loop as you pull the tape to help the label pop up, or start the label with your fingernail.
STEP 1
There are two parts to the dispenser: a cup and a lid. Place the cup on the table in front of you and rotate it until the holes are on the side closest to you.
STEP 2
Remove the first few labels off the roll so you are left with the paper backing. Then place the roll into the cup so that the text on the labels is upside-down.
STEP 3
Weave the label tape from the roll through the thin slit to the right of the large two holes.
STEP 4
Then push it back through the middle hole and out again through the left slit.
STEP 5
Finally, place the lid on dispenser. As you pull the tape through, the labels should pop up. Your labels are now ready to use!
Kannon Dispenser
STEP 1
Remove the first few labels on the roll. Open the dispenser and place the roll of labels on the center peg.
STEP 2
Snap the dispenser shut, press firmly until it clicks.
STEP 3
Thread the tail of the roll of labels under the first slit.
STEP 4
Weave the label backing down and through slit.
STEP 5
Pull the label paper to separate the label from backing. Your labels are now ready to use!